TRPT(8) NetBSD System Manager's Manual TRPT(8)
trpt -- transliterate protocol trace
trpt [-a] [-f] [-j] [-p hex-address] [-s] [-t] [-N system] [-M core]
trpt interrogates the buffer of TCP trace records created when a socket is marked for ``debugging'' (see setsockopt(2)), and prints a readable description of these records. When no options are supplied, trpt prints all the trace records found in the system grouped according to TCP con- nection protocol control block (PCB). The following options may be used to alter this behavior. -a In addition to the normal output, print the values of the source and destination addresses for each packet recorded. -f Follow the trace as it occurs, waiting a short time for addi- tional records each time the end of the log is reached. -j Just give a list of the protocol control block addresses for which there are trace records. -p Show only trace records associated with the protocol control block at the given address hex-address. -s In addition to the normal output, print a detailed description of the packet sequencing information. -t in addition to the normal output, print the values for all timers at each point in the trace. -M core Extract values associated with the name list from core. -N system Extract the name list from system. The recommended use of trpt is as follows. Isolate the problem and enable debugging on the socket(s) involved in the connection. Find the address of the protocol control blocks associated with the sockets using the -A option to netstat(1). Then run trpt with the -p option, supplying the associated protocol control block addresses. The -f option can be used to follow the trace log once the trace is located. If there are many sockets using the debugging option, the -j option may be useful in checking to see if any trace records are present for the socket in ques- tion.
The following sysctls are used by trpt. The TCP_DEBUG kernel option must be enabled. net.inet.tcp.debug Structure containing TCP sockets information used by trpt. net.inet.tcp.debx Number of TCP debug messages.
no namelist When the image doesn't contain the proper symbols to find the trace buffer; others which should be self explanatory.
The trpt command appeared in 4.2BSD.
Should also print the data for each input or output, but this is not saved in the trace record. The output format is inscrutable and should be described here. NetBSD 9.0 August 30, 2007 NetBSD 9.0
You can also request any man page by name and (optionally) by section: