RARPD(8) NetBSD System Manager's Manual RARPD(8)
rarpd -- Reverse ARP Daemon
rarpd [-adfl] [interface [...]]
rarpd services Reverse ARP requests on the Ethernet connected to interface. Upon receiving a request, rarpd maps the target hardware address to an IP address via its name, which must be present in both the ethers(5) and hosts(5) databases. If a host does not exist in both data- bases the translation cannot proceed and a reply will not be sent. In normal operation, rarpd forks a copy of itself and runs in the back- ground. Anomalies and errors are reported via syslog(3).
-a Listen on all the Ethernets attached to the system. If `-a' is omitted, an interface must be specified. -d Run in debug mode, with all the output to stderr. This option implies the -f option. -f Run in the foreground. -l Log all requests to syslog.
bpf(4), ethers(5), hosts(5) Finlayson, R., Mann, T., Mogul, J.C., and Theimer, M., A Reverse Address Resolution Protocol, RFC 903.
Craig Leres <email@example.com> and Steven McCanne <firstname.lastname@example.org>. Lawrence Berkeley Laboratory, University of California, Berkeley, CA. NetBSD 8.1 October 17, 2002 NetBSD 8.1
You can also request any man page by name and (optionally) by section: