IXG(4) NetBSD Kernel Interfaces Manual IXG(4)
ixg -- Intel(R) 10Gb Ethernet driver
ixg* at pci? dev ? function ?
The ixg driver provides support for PCI 10Gb Ethernet adapters based on the Intel(R) 82598EB, 82599, X540 and X550 Ethernet Controllers. The driver supports Jumbo Frames, TCP Segmentation Offload (TSO). For questions related to hardware requirements, refer to the documenta- tion supplied with your Intel 10GbE adapter. All hardware requirements listed apply to use with NetBSD. Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility con- figures the adapter to receive and transmit Jumbo Frames. On NetBSD, the maximum MTU size for Jumbo Frames is 9000 bytes. This driver version supports VLANs. For information on enabling VLANs, see ifconfig(8).
ixg%d: Unable to allocate bus resource: memory A fatal initialization error has occurred. ixg%d: Unable to allocate bus resource: interrupt A fatal initialization error has occurred. ixg%d: watchdog timeout -- resetting The device has stopped responding to the network, or there is a problem with the network connection (cable).
For general information and support, go to the Intel support website at: .: http://www.intel.com/support/
arp(4), ixv(4), netintro(4), vlan(4), ifconfig(8)
The ixg device driver comes from FreeBSD, where it is called ixgbe. It first appeared in NetBSD 6.0.
The ixg driver was written by Intel Corporation <firstname.lastname@example.org>. It was imported from FreeBSD into NetBSD by David Young <dyoung@NetBSD.org>.
The hardware supports a maximum MTU of 16114 bytes, but the NetBSD port of the driver supports only 9000 bytes. NetBSD 8.0 May 9, 2018 NetBSD 8.0
You can also request any man page by name and (optionally) by section: