IRDAATTACH(8) NetBSD System Manager's Manual IRDAATTACH(8)
irdaattach -- attach serial lines to IrDA frame driver
irdaattach [-d dongle] [-fHhlmnp] ttyname
irdaattach is used to assign a tty line to an IrDA frame level driver. The following operands are supported by irdaattach: -d dongle Sets the dongle type. The following dongles are supported: none No dongle tekram Tekram IR-210B jeteye Extended Systems JetEye actisys ACTiSYS IR-220L actisys+ ACTiSYS IR-220L+ litelink Parallax LiteLink girbil Greenwich GIrBIL The default is none. -f Print the name of the IrDA frame device that should be used to access the frames. -H Turn on DTR/CTS flow control. By default, no flow control is done. -h Turn on RTS/CTS flow control. By default, no flow control is done. -l Turn on the CLOCAL flag, making it possible to run SLIP on a cable without modem control signals (e.g. DTR, DSR, DCD). -m Maintain modem control signals after closing the line. Specifically, this disables HUPCL. -n Do not detach from invoking tty. -p Print process id to file. ttyname Specifies the name of the tty device. Ttyname should be a string of the form `ttyXX', or `/dev/ttyXX'. Only the super-user may attach a network interface. The frame driver is detached by killing the irdaattach process.
irdaattach tty00 ircomm -Y -d `irdaattach -p -f /dev/tty02`
Messages indicating that the specified interface does not exist, the requested address is unknown, or that the user is not privileged but tried to alter an interface's configuration.
daemon(3), irframe(4), irframetty(4), slattach(8)
The irdaattach command appeared in NetBSD 1.6. NetBSD 8.1 December 4, 2001 NetBSD 8.1
You can also request any man page by name and (optionally) by section: