FPA(4)                  NetBSD Kernel Interfaces Manual                 FPA(4)

     fpa, fea, fta -- DEC FDDI interface driver

     fpa* at pci? dev ? function ?
     fea* at eisa? slot ?

   alpha and pmax
     fta* at tc? slot ? offset ?

     Cards supported by the fpa, fea and fta device driver are:

           DEFPA   DEC PCI FDDI Controller

           DEFEA   DEC EISA FDDI Controller

           DEFTA   DEC TURBOchannel FDDI Controller

     respectively.  All variants of either controller are supported including
     the DAS and SAS configurations.

     fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d)
     The device probe detected that the DEFEA board is configured for a dif-
     ferent interrupt than the one specified in the kernel configuration file.

     fea%d: error: memory not enabled! ECU reconfiguration required  The
     device probe found that no device memory had been configured on the
     DEFEA.  The DEFEA can be configured with no device memory, this driver
     requires a minimum of 1K device memory be set up.  The ECU (EISA Configu-
     ration Utility) will need to be run to change the settings.

     arp(4), netintro(4), ifconfig(8)

     The fpa, fea and fta device driver and manual page were written by Matt

     Normally, the device driver will not enable the reception of SMT frames.
     However if the IFF_LINK1 flag is set, the device driver will enable the
     reception of SMT frames and pass them up to the Berkeley Packet Filter
     for processing.

NetBSD 8.1                      March 13, 1995                      NetBSD 8.1

You can also request any man page by name and (optionally) by section:


Use the DEFAULT collection to view manual pages for third-party software.

©1994 Man-cgi 1.15, Panagiotis Christias
©1996-2019 Modified for NetBSD by Kimmo Suominen