AUE(4) NetBSD Kernel Interfaces Manual AUE(4)
aue -- ADMtek AN986 and AN8511 Pegasus USB Ethernet driver
aue* at uhub? ukphy* at mii?
The aue driver supports the following adapters: @Home USB 10/100 Abocom DSB650TX Billionton Systems USB100 Compaq HNE-200 Corega FEther USB-TX Corega FEther USB-TXS D-Link DSB-650 D-Link DSB-650TX D-Link DSB-650TX-PNA I/O DATA USB ET/TX I/O DATA USB ET/TXS I/O DATA ETX-US2 Hawking UF100 Kingston KNU101TX LinkSys USB100TX LinkSys USB100H1 LinkSys USB10TA Melco Inc. LU-ATX Microsoft MN110 SOHOware NUB100 SMC 2202USB SMC 2206USB/ETH
The aue driver provides support for USB Ethernet adapters based on the ADMtek AN986 Pegasus and AN8511 Pegasus II chipsets. The Pegasus contains a 10/100 Ethernet MAC with MII interface and is designed to work with both Ethernet and HomePNA transceivers. Although designed to interface with 100Mbps peripherals, the existing USB standard specifies a maximum transfer speed of 12Mbps. Users should therefore not expect to actually achieve 100Mbps speeds with these devices. The Pegasus supports a 64-bit multicast hash table, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints. The aue driver supports the following media types: autoselect Enable automatic selection of the media type and options. The user can manually override the auto- matically selected mode by adding media options to the /etc/rc.conf file. 10baseT/UTP Set 10Mbps operation. The mediaopt option can also be used to enable full-duplex operation. Not spec- ifying full duplex implies half-duplex mode. 100baseTX Set 100Mbps (fast Ethernet) operation. The mediaopt option can also be used to enable full-duplex operation. Not specifying full duplex implies half-duplex mode. The aue driver supports the following media options: full-duplex Force full duplex operation. The interface will operate in half duplex mode if this media option is not specified. For more information on configuring this device, see ifconfig(8).
aue%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired. aue%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring.
arp(4), netintro(4), usb(4), ifconfig(8) ADMtek AN986 data sheet, http://www.admtek.com.tw.
The aue device driver first appeared in FreeBSD 4.0, and in NetBSD 1.5.
The aue driver was written by Bill Paul <email@example.com>. NetBSD 7.1.2 September 25, 2010 NetBSD 7.1.2
You can also request any man page by name and (optionally) by section: