VTE(4)                  NetBSD Kernel Interfaces Manual                 VTE(4)

NAME
     vte -- Vortex86 RDC R6040 Fast Ethernet driver

SYNOPSIS
     vte* at pci? dev ? function ?

     Configuration of PHYs is necessary.  See rdcphy(4).

DESCRIPTION
     The vte device driver provides support for RDC R6040 Fast Ethernet con-
     troller which is commonly found on Vortex86 System On a Chip (SoC).

     The RDC R6040 has integrated 10/100 PHY for 10/100Mbps support in full or
     half-duplex.  The controller supports interrupt moderation mechanism, a
     64-bit multicast hash filter, VLAN over-size frame and four station
     addresses.  The vte device driver uses three station addresses out of
     four as perfect multicast filter.

SYSCTL VARIABLES
     The following variables are available

     hw.vte.vte<x>.int_rxct
             Maximum number of packets to fire RX completion interrupt.  The
             accepted range is 0 (disable interrupt moderation) to 15, the
             default is 0.

     hw.vte.vte<x>.int_txct
             Maximum number of packets to fire TX completion interrupt.  The
             accepted range is 0 (disable interrupt moderation) to 15, the
             default is 0.

SEE ALSO
     ifmedia(4), mii(4), netintro(4), vlan(4), ifconfig(8)

     DM&P Electronics Inc. Vortex86, http://www.dmp.com.tw.

HISTORY
     The vte driver was written for FreeBSD by Pyun YongHyeon
     <yongari@FreeBSD.org> and ported to NetBSD by Manuel Bouyer
     <bouyer@NetBSD.org>.  The vte device driver first appeared in NetBSD 6.0.

NetBSD 6.0                     January 23, 2011                     NetBSD 6.0

You can also request any man page by name and (optionally) by section:

Command: 
Section: 
Architecture: 
Collection: 
 

Use the DEFAULT collection to view manual pages for third-party software.


©1994 Man-cgi 1.15, Panagiotis Christias <christia@softlab.ntua.gr>
©1996-2014 Modified for NetBSD by Kimmo Suominen