TRACEROUTE6(8)          NetBSD System Manager's Manual          TRACEROUTE6(8)

     traceroute6 -- print the route IPv6 packets will take to the destination

     traceroute6 [-adIlnrv] [-A as_server] [-f firsthop] [-g gateway]
                 [-m hoplimit] [-p port] [-q probes] [-s src] [-w waittime]
                 target [datalen]

     -A      Turn on AS# lookups and use the given server instead of the

     -a      Turn on AS# lookups for each hop encountered.

     -d      Debug mode.

     -f firsthop
             Specify how many hops to skip in trace.

     -g gateway
             Specify intermediate gateway (traceroute6 uses routing header).

     -I      Use ICMP6 ECHO instead of UDP datagrams.

     -l      Print both host hostnames and numeric addresses.  Normally
             traceroute6 prints only hostnames if -n is not specified, and
             only numeric addresses if -n is specified.

     -m hoplimit
             Specify maximum hoplimit.

     -n      Do not resolve numeric address to hostname.

     -p port
             Set UDP port number to port.

     -q probes
             Set the number of probe per hop count to probes.

     -r      Bypass the normal routing tables and send directly to a host on
             an attached network.  If the host is not on a directly-attached
             network, an error is returned.  This option can be used to send
             probes to a local host through an interface that has no route
             through it (e.g., after the interface was dropped by route6d(8)).

     -s src  Src specifies the source IPv6 address to be used.

     -v      Be verbose.

     -w waittime
             Specify the delay time between probes.

     The traceroute6 command exits 0 on success, and >0 on errors.

     ping(8), ping6(8), traceroute(8)

     The traceroute6 command first appeared in WIDE hydrangea IPv6 protocol
     stack kit.

NetBSD 7.1.2                  September 17, 2005                  NetBSD 7.1.2

You can also request any man page by name and (optionally) by section:


Use the DEFAULT collection to view manual pages for third-party software.

©1994 Man-cgi 1.15, Panagiotis Christias
©1996-2019 Modified for NetBSD by Kimmo Suominen