MOPPROBE(1)             NetBSD General Commands Manual             MOPPROBE(1)

NAME
     mopprobe -- MOP Probe Utility

SYNOPSIS
     mopprobe -a [-3 | -4]
     mopprobe [-3 | -4] interface

DESCRIPTION
     mopprobe prints the ethernet address and nodename of MOP SID message on
     the Ethernet connected to interface or all known interfaces if `-a' is
     given.

OPTIONS
     -a      Listen on all the Ethernets attached to the system.  If `-a' is
             omitted, an interface must be specified.

     -3      Ignore MOP V3 messages (Ethernet II).

     -4      Ignore MOP V4 messages (Ethernet 802.3).

SEE ALSO
     mopchk(1), mopcopy(1), moptrace(1), mopd(8)

AUTHORS
     Mats O Jansson <moj@stacken.kth.se>

NetBSD 6.0                      October 2, 1995                     NetBSD 6.0

You can also request any man page by name and (optionally) by section:

Command: 
Section: 
Architecture: 
Collection: 
 

Use the DEFAULT collection to view manual pages for third-party software.


©1994 Man-cgi 1.15, Panagiotis Christias <christia@softlab.ntua.gr>
©1996-2014 Modified for NetBSD by Kimmo Suominen