ISV(4)                  NetBSD Kernel Interfaces Manual                 ISV(4)

NAME
     isv -- IDEC Supervision/16 image capture board

SYNOPSIS
     isv0 at isa? port 0x2f0
     isv0 at isa? port 0x2e0
     isv0 at isa? port 0x3f0
     isv0 at isa? port 0x3e0

DESCRIPTION
     isv is a driver for the IDEC Supervision/16, an image capture board that
     plugs into a 16-bit ISA bus.  The IDEC Supervision/16 digitizes an NTSC
     television signal, storing a 512 x 480-pixel, 8-bit grayscale image in
     its 256kB dynamic RAM array every 1/30th of a second.  The host reads
     frames from the DRAM using 122881 16-bit I/O reads.  Reading frames from
     the Supervision/16 is quite slow: after the host reads a 16-bit word from
     the DRAM, the Supervision/16 state machine takes approximately 0.5
     microseconds to get ready for the next read.  Theoretically, a frame rate
     of approximately 10 frames per second is possible.  isv achieves a frame
     rate of approximately 6 frames per second.

SEE ALSO
     Programming the Supervision/16 Image Capture Board, IDEC, circa 1991.

HISTORY
     The isv device first appeared in NetBSD 5.0.

AUTHORS
     The isv driver was written by David Young <dyoung@NetBSD.org>.

BUGS
     Synchronizing with the hardware and reading frames from it is very CPU-
     intensive.

     isv will not detect the capture board if it is not attached to an active
     video source.  To force NetBSD to detect the capture board at any time,
     re-scan the ISA bus using, e.g., drvctl -r isa0.

NetBSD 6.0                       April 1, 2008                      NetBSD 6.0

You can also request any man page by name and (optionally) by section:

Command: 
Section: 
Architecture: 
Collection: 
 

Use the DEFAULT collection to view manual pages for third-party software.


©1994 Man-cgi 1.15, Panagiotis Christias <christia@softlab.ntua.gr>
©1996-2014 Modified for NetBSD by Kimmo Suominen