BLACKLISTCTL(8)         NetBSD System Manager's Manual         BLACKLISTCTL(8)

NAME
     blacklistctl -- display and change the state of blacklistd

SYNOPSIS
     blacklistctl dump [-abdnrw]

DESCRIPTION
     blacklistctl is a program used to display the state of blacklistd(8)

     The following options are available:

     -a      Show all database entries, by default it shows only the embryonic
             ones.

     -b      Show only the blocked entries.

     -d      Increase debugging level.

     -n      Don't display a header.

     -r      Show the remaining blocked time instead of the last activity
             time.

     -w      Normally the width of addresses is good for IPv4, the -w flag,
             makes the display wide enough for IPv6 addresses.

SEE ALSO
     blacklistd(8)

NOTES
     Sometimes the reported number of failed attempts can exceed the number of
     attempts that blacklistd(8) is configured to block.  This can happen
     either because the rule has been removed manually, or because there were
     more attempts in flight while the rule block was being added.  This con-
     dition is normal; in that case blacklistd(8) will first attempt to remove
     the existing rule, and then it will re-add it to make sure that there is
     only one rule active.

HISTORY
     blacklistctl appeared in NetBSD 7.

AUTHORS
     Christos Zoulas

NetBSD 7.1                      April 29, 2015                      NetBSD 7.1

You can also request any man page by name and (optionally) by section:

Command: 
Section: 
Architecture: 
Collection: 
 

Use the DEFAULT collection to view manual pages for third-party software.


©1994 Man-cgi 1.15, Panagiotis Christias <christia@softlab.ntua.gr>
©1996-2017 Modified for NetBSD by Kimmo Suominen