ICP(4)                  NetBSD Kernel Interfaces Manual                 ICP(4)

NAME
     icp -- ICP-Vortex and Intel Storage RAID driver

SYNOPSIS
     icp* at pci? dev ? function ?
     ld* at icp? unit ?
     icpsp* at icp? unit ?
     scsibus* at icpsp?

DESCRIPTION
     The icp driver provides support for the newer (post 1997) ICP-Vortex GDT
     and Intel Storage RAID controllers.

     The ld driver provides access to logical devices (disk arrays) presented
     by the controller.  The icpsp driver provides direct access to other SCSI
     devices attached to the controller, such as tape or CD-ROM drives.

DIAGNOSTICS
     pci_mem_find: expected mem type 00000000, found 00000002
             This message may be displayed during autoconfiguration if the
             controller's memory is mapped below 1MB in physical address
             space.  This can be disabled either through changing a setting in
             the controller's BIOS utility, or changing the position of a
             jumper on the board.  See your controller's documentation for
             more information.

SEE ALSO
     intro(4), ld(4), scsi(4)

HISTORY
     The icp driver first appeared in NetBSD 1.6, and was based on the FreeBSD
     and OpenBSD drivers of the same name.

BUGS
     ISA & EISA front-ends and a management interface are needed.

     Older PCI boards are not yet supported.

NetBSD 7.0                      April 20, 2002                      NetBSD 7.0

You can also request any man page by name and (optionally) by section:

Command: 
Section: 
Architecture: 
Collection: 
 

Use the DEFAULT collection to view manual pages for third-party software.


©1994 Man-cgi 1.15, Panagiotis Christias <christia@softlab.ntua.gr>
©1996-2014 Modified for NetBSD by Kimmo Suominen