ESP(4)                  NetBSD Kernel Interfaces Manual                 ESP(4)

NAME
     esp -- NCR 53C9x, Emulex ESP406, and Qlogic FAS408 SCSI driver

SYNOPSIS
   ISA bus
     esp0 at isa? port 0x230 irq ?

   PCMCIA
     esp* at pcmcia? function ?

   MCA
     esp* at mca? slot ?

   mac68k
     esp0 at obio?
     esp1 at obio?

   macppc
     esp0 at obio0 flags 0x00ff

   sun3x
     esp0 at obio0 addr 0x66000000 ipl 2 flags 0xff0f

   sparc
     dma0 at obio0 addr 0xfa001000 level 4 (Sun 4/300)
     esp0 at obio0 addr 0xfa000000 level 4 (Sun 4/300)

     dma0 at sbus0 slot ? offset ? (sun4c and sun4m)
     esp0 at sbus0 slot ? offset ? (sun4c)
     esp0 at dma0 (sun4m)

     dma* at sbus? slot ? offset ? (Sbus)
     esp* at sbus? slot ? offset ? (SBus, older PROMs)
     esp* at dma? (SBus)

     scsibus* at esp?

DESCRIPTION
     The esp driver provides support for the NCR 53C90, 53C94 and 53C96;
     Emulex ESP100, ESP100A, ESP200 and ESP406; and Qlogic FAS216 and FAS408
     SCSI controller chips found in a wide variety of systems and peripheral
     boards.  This includes the Qlogic ISA and VLB SCSI host adapters, and the
     Sun Fast SCSI buffered Ethernet for Sbus (FSBE/S, X1053A, Sun part #
     501-2015).

     For Qlogic PCI SCSI host adapters, use the isp(4) device.

CONFIGURATION
     The esp driver supports the following flags for use in config(1) files:

     bits 0-7:    disable disconnect/reselect for the corresponding SCSI tar-
                  get
     bits 8-15:   disable synchronous negotiation for the corresponding SCSI
                  target
     bits 16-23:  disable tagged queuing for the corresponding SCSI target

     "Target" is synonymous with SCSI ID number.

     Note that SCSI tape drives should be allowed to perform disconnect/rese-
     lect or performance will suffer.

SEE ALSO
     cd(4), ch(4), intro(4), le(4), mca(4), pcmcia(4), scsi(4), sd(4), ss(4),
     st(4), uk(4)

NetBSD 7.0                     December 3, 2001                     NetBSD 7.0

You can also request any man page by name and (optionally) by section:

Command: 
Section: 
Architecture: 
Collection: 
 

Use the DEFAULT collection to view manual pages for third-party software.


©1994 Man-cgi 1.15, Panagiotis Christias <christia@softlab.ntua.gr>
©1996-2014 Modified for NetBSD by Kimmo Suominen